Tuesday, March 19, 2019
Rates of Reaction :: Papers
Rates of Reaction presage (Na2 S2 O3 + 2HCL --- 2NaCl + SO2 + S + H2O) This is the equation for Sodium Thiosulphate reacting with 2 Molar of Hydrochloric tart. There atomic number 18 a number of variables in the experiment which essential be controlled in order for the experiment to be a fair test. These include temperature, which must be kept constant throughout the experiment or the results would not match. The experiment leave behind be performed at room temperature (Around 25 degrees). some other variable is volume of Hydrochloric acid, which must be kept the same as well. For this experiment, I ordain be using 5cm of HCL. If all of these variables are controlled, and then the experiment leave behind be a fair test. However, there will be a degree of human error because there is no definate point at which the cross disappears, it relies on human judgement. My prediction is that as the concentration of Sodium Thiosulphate decreases, the r ate of response will decrease hence and the reaction will take longer to complete. This is the basic principle of the ingredient Theory. The particle theory is that if there are less atoms to collide into each other and react, then the reaction will be slower than if there were more than atoms to collide. Therefore, if the concentration, so number of atoms if lower, then the amount of collisions between Sodium Thiosulphate and Hydrochloric Acid will be less frequent. Also, when the concentration of Sodium Thiosulphate is higher, the water will get cloudy faster due to the fact that there will be less water available to disrupt the reaction. IMAGE As the reaction takes place, the amount of Hydrochloric Acid and Sodium Thiosulphate decreases, which therefore decreases the probability of the devil atoms smasher each other, reacting. The reaction will slow down, because if two Thiosulphate atoms or two HCL atoms collide, then nothing will happen. This is the particle theory. Method Equipment Beakers Measuring cylinders
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment